Welcome to MyAquarium Shop Online
Categories

DI De-ionization Aquarium Mixed Bed Ion Exchange Resin – 0.5 L

Open Sidebar Close Sidebar

DI De-ionization Aquarium Mixed Bed Ion Exchange Resin – 0.5 L

(4 customer reviews)

RM20.00

Earn 20 points upon purchasing this product.

  • For water purification of raw tape water to remove unwanted nutrient
  • For achieving ” Pure water ” with Zero TDS
  • High Absorption rate
Use 2000 points to purchase this product!

DI De-ionization Aquarium Mixed Bed Ion Exchange Resin – 0.5L

DI Resin is necessary to reduce Total Dissolved Solids (TDS) to zero and is usually use as the last stage filtration of an RO/DI unit. It is not necessary to use the expensive proprietary DI cartridges that other RO manufacturers sell. Simply buy a refillable DI cartridge if you don’t have one already and fill with DI resin. You’ll save money and get the same results.

 

To get maximum life from your DI resin please takes the following steps

 

  • Ensure optimal operation of your RO membrane. The higher your membranes rejection rate the fewer TDS your product water will contain resulting in longer lasting resin. The best way to keep the membrane rejection rate up is to monitor and change your prefilters appropriately as well as maintain at least 50psi going into the membrane.
  • Ensure the resin is packed in the cartridge securely. The resin should be packed very tightly. When squeezed, there should be almost no flex to the cartridge.
  • The initial couple minutes of water from your RO membrane will always be high, this is commonly referred to as TDS creep. Diverting the first few minutes of water down the drain can often greatly reduce DI resin consumption.
  • Maintain low levels of carbon dioxide in your water supply.  Excess carbon dioxide will deplete DI resin quickly. If you are depleting resin quickly and have already :addressed the two options above, excess carbon dioxide is the likely culprit. You have two choices:
    • Collect the water coming from your RO system in a large container, add a powerhead or air stone and allow the CO2 to gas off. Then pump the water though your DI resin.
    • Skip all that mess and just buy resin in bulk.

** The life span of the DI resin will very much depends on the TDS reading of the tape water source.

di resin cartriges

di resin cartriges

di resin info

di resin info

One pack of 0.5L DI resin is enough to fill up ;

1 x Refillable cartridges 

2 x T33 clear refillable housing 

 

4.0

OVERALL

75% Complete
25% Complete
0% Complete
0% Complete
25% Complete

4 reviews for DI De-ionization Aquarium Mixed Bed Ion Exchange Resin – 0.5 L

  1. Avatar

    YAJESH (verified owner)

  2. Avatar

    Md Khairul Ikhwan (verified owner)

  3. Avatar

    WENG KONG ONG (verified owner)

  4. Avatar

    Stanley Tan (verified owner)

Add a review

Your email address will not be published. Required fields are marked *

You may also like…

WhatsApp us